Taper Reamer 0.5 Inch Shank Diameter Trail Gear$126.05 Taper Reamer 0.5 Inch Shank Diameter Trail Gear quantity Add to cart SKU: 130324-KIT Categories: Pitman Arm, Pitman Arms Description Additional information Reviews (0) Description Taper Reamer. This is the perfect taper reamer for reaming out Toyota and Suzuki pitman arms for the larger, more commonly used FJ80 tie rod ends, like the ones offered in our popular high steer kits. Our taper reamer is 1.0 Inch of taper for every 10.0 Inch of length and is also expressed as 1.2 Inch of taper for every foot of length. The reamer is made from M2 high speed steel with a 0.5 Inch shank diameter for drill press or mill and a 0.375 Inch square end for use with a tap wrench. Anyone can use this tool. You simply ream out the hole in the pitman arm until you can slide the shank of the TRE in, tighten the castle nut, and install the cotter pin. It takes just a few minutes and can be done with hand tools.Specs: Warranty: 12 Month Limited Warranty Sold As: Each Material: Steel Finish: Bare Color: Grey Fits: Non-vehicle specific Additional information Weight 0.45 lbs Dimensions 7.5 × 7.5 × 3.5 in Reviews There are no reviews yet. Be the first to review “Taper Reamer 0.5 Inch Shank Diameter Trail Gear” Cancel replyYour email address will not be published. Required fields are marked *Your rating * Rate… Perfect Good Average Not that bad Very poor Your review *Name * Email * Related products Pitman Arm/Pitman ArmsPitman Arm For 79-95 Pickup 85-95 4Runner Trail Gear $190.25 Select options